About the Apex Optic Mount for

Mounting an enclosed emitter optic like the Aimpoint ACRO P-1 or P-2, the Steiner MPS, or the Lead & Steel Pandora PB-3 to your Glock MOS pistol used to mean fighting with adapter plates, extra screws, and zero retention worries. The Apex Optic Mount changes that. Machined from solid billet steel with a black oxide finish, this mount gives you a direct, rock-solid mounting solution for your factory Glock MOS slide. No plastic. No rattling. No guessing if your optic will hold zero after a few hundred rounds.

This mount is built for shooters who actually carry and run their guns hard. Whether you’re stacking rounds on steel at the range, working through a concealed-carry class, or hunting in wet brush, the steel construction absorbs recoil and maintains a consistent return to zero. The black oxide finish resists rust and glare, keeping your setup low-profile and functional in all conditions.

Key benefits for your Glock MOS pistol:

• Direct mount to factory MOS slides – No shims, no extra plates. This mount bolts straight to your Glock MOS cut, keeping the optic low and secure.
• Compatible with three popular enclosed optics – Works with the Aimpoint ACRO P-1 & P-2, Steiner MPS, and Lead & Steel Pandora PB-3. One mount covers your needs for duty, carry, or hunting.
• Steel construction for real-world use – Machined from billet steel in Arizona (Apex Tactical is an American manufacturer). This mount is tough enough to handle holster wear, drops, and hard use without deforming.
• Mounting hardware included – Screws are supplied in the package. Just clean your slide, apply the screws, and torque to 15 in-lb. No extra trips to the hardware store.
• Simple installation – Clean the MOS slide surface, place the mount, and torque the screws. That’s it. You’re ready to zero your optic and get back to shooting.

Specs and fitment: This mount is designed exclusively for Glock pistols with the factory MOS (Modular Optic System) slide cut. It does not fit non-MOS slides or aftermarket slide cuts. The mount itself is made from 4140 steel, black oxide finished, and weighs approximately 0.4 ounces. Optic mounting screws are included; we recommend using a torque wrench set to 15 in-lb for installation. Clean the slide contact surface before mounting to ensure a secure fit.

At $60, this is